CLI Guide

• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
in | out | both Enter the keyword in, out, or both to debug incoming
interfaces, outgoing interfaces, or both incoming and
outgoing interfaces.
vlan vlan-id Enter the keyword vlan then the VLAN ID. The range is
from 1 to 4094.
count value Enter the keyword count then the number of debug
outputs. The range is from 1 to 100.
Defaults Debug disabled.
Command Modes EXEC Privilege
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
protocol-tunnel
Enable protocol tunneling on a stacked (Q-in-Q) VLAN for specified protocol packets.
Syntax
protocol-tunnel {rate-limit rate| stp}
To disable protocol tunneling for a Layer 2 protocol, use the no protocol-
tunnel command.
Parameters
rate-limit rate Enter the keyword rate-limit then a number for the rate-
limit for tunneled packets on the VMAN. The range is from
64 to 320.
stp Enter the keyword stp to enable protocol tunneling on a
spanning tree, including STP, MSTP, RSTP, and PVST.
Defaults none
Command Modes CONF-IF-VLAN
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
Service Provider Bridging
1387