CLI Guide

example, 4096, 8192, 16384, and so on. The default is

32768 packets.

Defaults 32768 packets

Command Modes CONFIGURATION

Supported Modes Full–Switch Mode

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information Sample-rate is the average number of packets skipped before the sample is taken.

This command changes the global default sampling rate. You can configure an

interface to use a different sampling rate than the global sampling rate. If the value

entered is not a correct power of 2, the command generates an error message

with the previous and next power of 2 value. Select one of these two packet

numbers and re-enter the command.

Commands

sflow sample-rate (Interface) — changes the interface sampling rate.

sflow sample-rate (Interface)

Change the interface default sampling rate.

Syntax

sflow sample-rate value

To return to the default sampling rate, use the no sflow sample-rate

command.

Parameters

value Enter the sampling rate value. The range is from 256 to

8388608 packets. Enter values in powers of 2 only; for

example, 4096, 8192, and 16384. The default is the Global

default sampling.

Defaults The Global default sampling.