CLI Guide

Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#conf
Dell(conf)# ip ssh rhostsfile flash://shosts
Dell(conf)#
Usage Information
This command specifies the rhost file used for host-based authentication. This
creates/ file overwrites the flash:/ADMIN_DIR/ssh/shosts file and deletes
the user-specified file. Even though this command is a global configuration
command, it does not appear in the running configuration because you only need
to run this command once.
This file contains hostnames and usernames, for which hosts and users, rhost-
authentication can be allowed.
NOTE: For rhostfile and pub-key-file, the administrator must FTP the
file to the switch.
ip ssh rekey
Configures the time rekey-interval or volume rekey-limit threshold at which to re-generate the SSH key
during an SSH session.
Syntax
ip ssh rekey [time rekey-interval] [volume rekey-limit]
To reset to the default, use no ip ssh rekey [time rekey-interval]
[volume rekey-limit] command.
Parameters
time minutes Enter the keywords time then the amount of time in
minutes. The range is from 10 to 1440 minutes. The default
is 60 minutes
volume rekey-
limit
Enter the keywords volume then the amount of volume in
megabytes. The range is from 1 to 4096 to megabytes. The
default is 1024 megabytes
Defaults The default time is 60 minutes. The default volume is 1024 megabytes.
Command Modes CONFIGURATION mode
Supported Modes Full–Switch
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
1358
Security