CLI Guide

Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON, S6000, S6000–ON, S5000,
S4810, S4820T, S3048–ON, S4048–ON, MXL, C9010,
S3100 series, and Z9100-ON.
Usage Information
• You can select one or more ciphers from the list.
• The default list of supported ciphers is same irrespective of whether FIPS mode
is enabled or disabled.
• Client-supported cipher list gets preference over the server-supported cipher
list in selecting the cipher for the SSH session.
• When the cipher (-c) option is used with the SSH CLI, it overrides the
configured or default cipher list.
• When FIPS is enabled or disabled, the client ciphers get default configuration.
ip ssh connection-rate-limit
Configure the maximum number of incoming SSH connections per minute.
Syntax
ip ssh connection-rate-limit 1-10
Parameters
1-10 Enter the number of maximum numbers of incoming SSH
connections allowed per minute. The range is from 1 to 10
per minute. The default is 10 per minute.
Defaults 10 per minute
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ip ssh hostbased-authentication
Enable hostbased-authentication for the SSHv2 server.
Syntax
ip ssh hostbased-authentication enable
To disable hostbased-authentication for SSHv2 server, use the no ip ssh
hostbased-authentication enable command.
1354
Security