CLI Guide

ManualsBrandsDell ManualsAccess PlatformsFN IO Module

1341

Defaults Not configured.

Command Modes CONFIGURATION

Supported Modes All Modes

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.4(0.0) Supported on the FN I/O Aggregator.

tacacs-server host

Specify a TACACS+ host.

Syntax

tacacs-server host {hostname | ipv4-address | ipv6-address}

[port number] [timeout seconds] [key key]

Parameters

hostname Enter the name of the TACACS+ server host.

ipv4-address |

ipv6-address

Enter the IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X)

of the TACACS+ server host.

port number (OPTIONAL) Enter the keyword port then a number as the

port to be used by the TACACS+ server. The range is from

zero (0) to 65535. The default is 49.

timeout seconds (OPTIONAL) Enter the keyword timeout then the number

of seconds the switch waits for a reply from the TACACS+

server. The range is from 0 to 1000. The default is 10

seconds.

key key

(OPTIONAL) Enter the keyword key then a string up to 42

characters long as the authentication key. This

authentication key must match the key specified in the

tacacs-server key for the TACACS+ daemon.