CLI Guide

To disable this function or return to the default value, use the no radius-server
deadtime command.
Parameters
seconds Enter a number of seconds during which non-responsive
RADIUS servers are skipped. The range is from 0 to
2147483647 seconds. The default is 0 seconds.
Defaults 0 seconds
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Supported on the M I/O Aggregator.
radius-server host
Configure a RADIUS server host.
Syntax
radius-server host {hostname | ipv4-address | ipv6-address}
[auth-port port-number] [retransmit retries] [timeout seconds]
[key [encryption-type] key]
Parameters
hostname Enter the name of the RADIUS server host.
ipv4-address |
ipv6-address
Enter the IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X)
of the RADIUS server host.
auth-port port-
number
(OPTIONAL) Enter the keywords auth-port then a number
as the port number. The range is from zero (0) to 65535.
The default port-number is 1812.
retransmit retries (OPTIONAL) Enter the keyword retransmit then a number
as the number of attempts. This parameter overwrites the
radius-server retransmit command. The range is
from zero (0) to 100. The default is
3 attempts.
timeout seconds (OPTIONAL) Enter the keyword timeout then the seconds
the time interval the switch waits for a reply from the
RADIUS server. This parameter overwrites the radius-
server timeout
command. The range is from 0 to 1000.
The default is 5 seconds.
key [encryption-
type] key
(OPTIONAL) Enter the keyword key then an optional
encryption-type and a string up to 42 characters long as the
authentication key. The RADIUS host server uses this
1340
Security