CLI Guide

line — enables and configures console and virtual terminal lines to the system.
access-class
Restrict incoming connections to a particular IP address in a defined IP access control list (ACL).
Syntax
access-class access-list-name
To delete a setting, use the no access-class command.
Parameters
access-list-name Enter the name of an established IP Standard ACL.
Defaults Not configured.
Command Modes LINE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
line — applies an authentication method list to the designated terminal lines.
ip access-list standard — names (or selects) a standard access list to filter based on
the IP address.
ip access-list extended — names (or selects) an extended access list based on the
IP addresses or protocols.
enable password
Change the password for the enable command.
Syntax
enable password [level level] [encryption-type] password
To delete a password, use the no enable password [encryption-type]
password [level level] command.
Parameters
level level (OPTIONAL) Enter the keyword level then a number as the
level of access. The range is from 1 to 15.
encryption-type
(OPTIONAL) Enter the number 7 or 0 as the encryption type.
Enter a 7 then a text string as the hidden password. The text
string must be a password that was already encrypted by a
Dell Networking router.
Security
1327