CLI Guide

Parameters
description Enter a description to identify the rapid spanning tree (80
characters maximum).
Defaults none
Command Modes SPANNING TREE (The prompt is “config-rstp”.)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
protocol spanning-tree rstp — enters SPANNING TREE mode on the switch.
disable
Disable RSTP globally on the system.
Syntax
disable
To enable Rapid Spanning Tree Protocol, use the no disable command.
Defaults RSTP is disabled.
Command Modes CONFIGURATION RSTP (conf-rstp)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
protocol spanning-tree rstp — enters SPANNING TREE mode on the switch.
forward-delay
Configure the amount of time the interface waits in the Listening State and the Learning State before
transitioning to the Forwarding State.
Syntax
forward-delay seconds
Rapid Spanning Tree Protocol (RSTP)
1299