CLI Guide

invalid value should be at least three times the update timer
value. The range is from zero (0) to 4294967295. The
default is 180 seconds.
holddown Enter the number of seconds to specify a time interval
during which the route is marked as unreachable but still
sending RIP packets. The holddown value should be at least
three times the update timer value. The range is from zero
(0) to 4294967295. The default is 180 seconds.
flush Enter the number of seconds to specify the time interval
during which the route is advertised as unreachable. When
this interval expires, the route is flushed from the routing
table. The flush value should be greater than the update
value. The range is from zero (0) to 4294967295. The
default is 240 seconds.
Defaults
• update = 30 seconds
• invalid = 180 seconds
• holddown = 180 seconds
• flush = 240 seconds
Command Modes ROUTER RIP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If you change the timers on one router, also synchronize the timers on all routers
in the RIP domain.
version
Specify either RIP version 1 or RIP version 2.
Syntax
version {1 | 2}
To return to the default version setting, use the no version command.
Parameters
1 Enter the keyword 1 to specify RIP version 1.
2 Enter the keyword 2 to specify RIP version 2.
Defaults The system sends RIPv1 and receives RIPv1 and RIPv2.
1282
Routing Information Protocol (RIP)