CLI Guide

router rip
To configure and enable RIP, enter ROUTER RIP mode.
Syntax
router rip
To disable RIP, use the no router rip command.
Defaults Disabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To enable RIP, assign a network address using the network command.
Example
Dell(conf)#router rip
Dell(conf-router_rip)#
Related
Commands
network — enables RIP.
show config
Display the changes you made to the RIP configuration. The default values are not shown.
Syntax
show config
Command Modes ROUTER RIP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf-router_rip)#show config
!
router rip
network 172.31.0.0
passive-interface TenGigabitEthernet 0/1
Dell(conf-router_rip)#
Routing Information Protocol (RIP)
1279