CLI Guide

plus the five pre-defined profiles, for a total of 31 WRED
profiles.
Pre-defined Profiles: wred_drop, wred-ge_y, wred_ge_g,
wred_teng_y, wred_teng_g.
Defaults The five pre-defined WRED profiles. When you configure a new profile, the
minimum and maximum threshold defaults to predefined wred_ge_g values.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Use the default pre-defined profiles or configure your own profile. You cannot
delete the pre-defined profiles or their default values. This command enables
WRED configuration mode — (conf-wred).
dscp
Sets the number of specific DSCP values for a color map profile to yellow or red.
Syntax
dscp {yellow | red} [list-dscp-values]
To remove a color policy map profile, use the no dscp {yellow | red}
[dscp-list] command.
Parameters
Yellow Enter the yellow keyword. Traffic marked as yellow delivers
traffic to the egress queue which either transmits the packet
if it has available bandwidth or drops the packet due to no
ability to send.
Red Enter the red keyword. Traffic marked as red is dropped.
dscp-list Enter a list of IP DSCP values. The dscp-list parameter
specifies the full list of IP DSCP value(s) for the specified
color. Each DSCP value in a list is separate values by
commas – no spaces (1,2,3) or indicates a list of values
separated by a hyphen (1-3). Range is 0 to 63.
Defaults None
Command Modes CONFIG-COLOR-MAP
Supported Modes Full–Switch
1258
Quality of Service (QoS)