CLI Guide

Field Description
Estimated CAM
per Port
Indicates the number of free CAM entries required (for the
classification rules) to apply the input policy map on a single
interface.
NOTE: The CAM entries for the default rule are not
included in this column; a CAM entry for the default rule
is always dedicated to a port and is always available for
that interface.
Status (Allowed
ports)
Indicates if the input policy map configuration on an
interface belonging to a linecard/port-pipe is successful —
Allowed (n) — or not successful — Exception. The allowed
number (n) indicates the number of ports in that port-pipe
on which the Policy Map can be applied successfully.
NOTE: In a Layer 2 Policy Map, IPv4/IPv6 rules are not allowed; therefore, the
output contains only L2ACL CAM partition entries.
Example
Dell# test cam-usage service-policy input pmap_l2 stack-unit
all
For a L2 Input Policy Map pmap_l2, the output must be as
follows,
Stack-unit|Portpipe|CAM Partition|Available CAM|Estimated CAM|
Status
| | | |per Port |
(Allowed ports)
0 0 L2ACL 500 200
Allowed (2)
1 L2ACL 100 200
Exception
1 0 L2ACL 1000 200
Allowed (5)
1 1 L2ACL 0 200
Exception
…
…
…
13 1 L2ACL 400 200
Allowed (2)
Dell#
trust
Specify dynamic classification (DSCP) or dot1p to trust.
Syntax
trust {diffserv [fallback]| dot1p [fallback]}
Parameters
diffserv Enter the keyword diffserv to specify trust of DSCP
markings.
dot1p Enter the keyword dot1p to specify trust dot1p
configuration.
1254
Quality of Service (QoS)