CLI Guide

characters maximum). This specifies the input QoS policy
assigned to the queue under policy-map-input and
output QoS policy under policy-map-output context.
Defaults none
Command Modes CONFIGURATION (conf-policy-map-in and conf-policy-map-out)
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command assigns a class map or QoS policy to different queues.
Related
Commands
service-policy output — applies an output policy map to the selected interface.
set
Mark outgoing traffic with a differentiated service code point (DSCP) or dot1p value.
Syntax
set {ip-dscp value | mac-dot1p value}
Parameters
ip-dscp value (OPTIONAL) Enter the keywords ip-dscp then the IP DSCP
value. The range is from 0 to 63.
mac-dot1p value Enter the keywords mac-dot1p then the dot1p value. The
range is from 0 to 7.
Defaults none
Command Modes CONFIGURATION (conf-qos-policy-in)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
After the IP DSCP bit is set, other QoS services can then operate on the bit settings.
Quality of Service (QoS)
1245