CLI Guide

Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The input policy map is used to classify incoming traffic to different flows using
class-map, QoS policy, or incoming packets DSCP. This command enables Policy-
Map-Input Configuration mode (conf-policy-map-in).
Related
Commands
service-queue — assigns a class map and QoS policy to different queues.
policy-aggregate — allows an aggregate method of configuring per-port QoS
using policy maps.
service-policy input — applies an input policy map to the selected interface.
policy-map-output
Create an output policy map.
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name
command.
Parameters
policy-map-name Enter the name for the policy map in character format (32
characters maximum).
Defaults none
Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To assign traffic to different flows using QoS policy, use the Output Policy map.
This command enables Policy-Map-Output Configuration mode (conf-policy-
map-out).
Related
Commands
service-queue — assigns a class map and QoS policy to different queues.
Quality of Service (QoS)
1239