CLI Guide

qos-policy-output — creates an output QoS-policy on the router.
match ip dscp
Use a differentiated services code point (DSCP) value as a match criteria.
Syntax
match {ip | ipv6 | ip-any} dscp dscp-list [set-ip-dscp value]
To remove a DSCP value as a match criteria, use the no match {ip | ipv6 |
ip-any} dscp dscp-list [[multicast] set-ip-dscp value] command.
Parameters
ip Enter the keyword ip to support IPv4 traffic.
ipv6 Enter the keyword ipv6 to support IPv6 traffic
ip-any Enter the keyword ip-any to support IPv4 and IPv6 traffic.
dscp-list Enter the IP DSCP values that is to be the match criteria.
Separate values by commas — no spaces ( 1,2,3 ) or indicate
a list of values separated by a hyphen (1-3). The range is
from 0 to 63.
set-ip-dscp value (OPTIONAL) Enter the keywords set-ip-dscp then the IP
DSCP value. The matched traffic is marked with the DSCP
value. The range is from 0 to 63.
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.5(0.0) Introduced the ipv6 and ip-any options on the MXL
10/40GbE Switch.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To access this command, enter the class-map command. After the class map is
identified, you can configure the match criteria.
The match ip dscp and match ip precedence commands are mutually
exclusive.
Up to 64 IP DSCP values can be matched in one match statement. For example, to
indicate IP DCSP values 0 1 2 3 4 5 6 7, enter either the match ip dscp
0,1,2,3,4,5,6,7 or match ip dscp 0-7 command.
NOTE: Only one of the IP DSCP values must be a successful match criterion,
not all of the specified IP DSCP values must match.
1234
Quality of Service (QoS)