CLI Guide

Supported Modes Full–Switch
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Introduced on the MXL switch.
Usage Information To access this command, enter the class-map command. After the class map is
identified, you can configure the match criteria.
Use this command to match an IP class-map against a single VRF ID .
Related
Commands
class-map — identifies the class map.
description
Add a description to the selected policy map or QoS policy.
Syntax
description {description}
To remove the description, use the no description {description}
command.
Parameters
description Enter a description to identify the policies (80 characters
maximum).
Defaults none
Command Modes CONFIGURATION (policy-map-input and policy-map-output; conf-qos-policy-in
and conf-qos-policy-out; wred)
Supported Modes Programmable-Mux (PMUX)
Full-Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
policy-map-output — creates an output policy map.
Quality of Service (QoS)
1233