CLI Guide

match ip vlan
Uses a VLAN as the match criterion for an L3 class map.
Syntax
match ip vlan vlan-id
To remove VLAN as the match criterion, use the no match ip vlan vlan-id
command.
Parameters
vlan vlan-id Enter the keyword vlan and then the ID of the VLAN. The
range is from 1 to 4094.
Defaults none
Command Modes CONF-CLASS-MAP
Supported Modes Full–Switch
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Introduced on the MXL switch.
Usage Information To access this command, enter the class-map command. After the class map is
identified, you can configure the match criteria.
Use this command to match an IP class-map against a single VLAN ID .
Related
Commands
class-map — identifies the class map.
match ip vrf
Uses a VRF as the match criterion for an L3 class map.
Syntax
match ip vrf vrf-id
To remove VRF as the match criterion, use the no match ip vrf vrf-id
command.
Parameters
vlan vlan-id Enter the keyword vrf and then the ID of the VRF. The
range is from 1 to 63.
Defaults none
Command Modes CONF-CLASS-MAP
1232
Quality of Service (QoS)