CLI Guide

64. The range is from 0 to 40000000. The default
granularity is Megabits per second (Mbps).
rate Enter the outgoing rate in multiples of 10 Mbps. The range is
from 10 to 10000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 0
to 10000. The default is 50.
Defaults Granularity for rate is Mbps unless you use the kbps option.
Command Modes QOS-POLICY-OUT
Supported Modes Programmable-Mux (PMUX)
Full-Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information When you apply rate-shape in QoS policy both on the Queue Level and in
Aggregate mode, the queue-based shaping occurs first then aggregate rate
shaping.
service-class dynamic dot1p
Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all
interfaces (from CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE
mode entry.
Syntax
service-class dynamic dot1p
To return to the default setting, use the no service-class dynamic dot1p
command.
Defaults All dot1p traffic is mapped to Queue 0 unless you enable the service-class
dynamic dot1p command. The default mapping is as follows:
dot1p Queue ID
0 0
1 0
2 0
3 1
4 2
5 3
1224
Quality of Service (QoS)