CLI Guide

Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits
per second (Kbps). Make the following value a multiple of
64. The range is from 0 to 40000000. The default
granularity is Megabits per second (Mbps).
committed-rate Enter the bandwidth in Mbps. The range is from 0 to 10000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 16
to 200000. The default is 50.
peak peak-rate (OPTIONAL) Enter the keyword peak then a number to
specify the peak rate in Mbps. The range is from 0 to 10000.
vlan vlan-id (OPTIONAL) Enter the keyword vlan then a VLAN ID to
police traffic to those specific VLANs. The range is from 1 to
4094.
Defaults Granularity for commited-rate and peak-rate is Mbps unless you use the kbps
option.
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
NOTE: Per port rate police is supported for Layer 2 tagged and untagged
switched traffic and for Layer 3 traffic. Per VLAN rate police is supported on
only tagged ports with Layer 2 switched traffic.
On one interface, you can configure the rate police command for a VLAN or
you can configure the rate police command for an interface. For each physical
interface, you can configure three
rate police commands specifying different
VLANS.
For each physical interface, you can configure three rate police commands
specifying different VLANs.
Related
Commands
rate-police — specifies traffic policing on the selected interface.
rate-shape
Shape the traffic output on the selected interface.
Syntax
rate shape [kbps] rate [burst-KB]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits
per second (Kbps). Make the following value a multiple of
Quality of Service (QoS)
1223