CLI Guide

Parameters
value Enter a dot1p list number and value. The list number range is
from 0 to 7. The range is from 0 to 3.
Defaults For each dot1p Priority, the default CoS queue value is:
• dot1p CoS Queue
0 0-7
1 0-7
2 0-7
3 0-7
4 0-7
5 0-7
6 0-7
7 0-7
Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Full-Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information To apply dot1p-queue-mapping, use the service-class dynamic dot1p
command.
Per-Port QoS Commands
Per-port QoS (port-based QoS) allows you to define the QoS configuration on a per-physical-port basis.
dot1p-priority
Assign a value to the IEEE 802.1p bits on the traffic this interface receives.
Syntax
dot1p-priority priority-value
Quality of Service (QoS)
1221