CLI Guide

To return to the default, use the no vlan max-age command.
Parameters
vlan vlan-range Enter the keyword vlan then the VLAN numbers. The range
is from 1 to 4094.
max-age seconds Enter the keywords max-age then the time interval, in
seconds, that the system waits before refreshing
configuration information. The range is from 6 to 40
seconds. The default is 20 seconds.
Defaults 20 seconds
Command Modes CONFIGURATION (conf-pvst)
Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
vlan bridge-priority — sets the bridge-priority value.
vlan forward-delay — changes the time interval before the system transitions to the
forwarding state.
vlan hello-time — changes the time interval between BPDUs.
show spanning-tree pvst — displays the PVST+ configuration.
Per-VLAN Spanning Tree Plus (PVST+)
1219