CLI Guide

Parameters

interface Enter the one of the following keywords and slot/port

information:

• For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

destination Enter the keyword destination to indicate the interface

destination.

direction {rx | tx |

both}

Enter the keyword direction followed by one of the

packet directional indicators.

• rx: to monitor receiving packets only.

• tx: to monitor transmitting packets only.

• both: to monitor both transmitting and receiving

packets.

Defaults none

Command Modes MONITOR SESSION (conf-mon-sess-session-ID)

Supported Modes All Modes

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.4(0.0) Supported on the FN I/O Aggregator.

Example

Dell(conf-mon-sess-11)#source tengig 0/1 destination tengig

0/8 direction

Dell(conf-mon-sess-11)#

Usage Information The monitored (source) interface must be a server-facing interface in the format

slot/port, where valid slot number is 0 and server-facing port numbers are from 1

to 8.

Port Monitoring

1195