CLI Guide

To display the running configuration for all monitor sessions, use the show
running-config monitor session command.
Parameters
session-ID (OPTIONAL) Enter a session identification number. The
range is from 0 to 65535.
Defaults none
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
Usage Information The monitoring command is saved in the running configuration at the Monitor
Session mode level and can be restored after a chassis reload.
Example
Dell#show run monitor session
!
monitor session 5
source TenGigabitEthernet 0/4 destination TenGigabitEthernet
0/5 direction rx
!
monitor session 20
source TenGigabitEthernet 0/3 destination TenGigabitEthernet
0/2 direction both
Dell#
Dell#show run monitor session 20
!
monitor session 20
source TenGigabitEthernet 0/3 destination TenGigabitEthernet
0/2 direction both
Dell#
Related
Commands
monitor session — creates a session for monitoring.
show monitor session — displays a monitor session.
source (port monitoring)
Configure a port monitor source.
Syntax
source interface destination interface direction {rx | tx |
both}
To disable a monitor source, use the no source interface destination
interface direction {rx | tx | both} command.
1194
Port Monitoring