CLI Guide

Version Description
7.4.1.0 Introduced on the E-Series.
Usage Information To monitor traffic with particular flows the interface, appropriate ACLs has be
applied in ingress direction. Flow- based is not supported in the tx direction. Even
though we can configure it in both the direction, only rx will work.
The flow- based enable command has to be applied as a monitor session with
some configuration which is already present in it, other wise flow- based will not
take effect.
Related
Commands
monitor session – enables a monitoring session.
rate-limit
Configure the rate-limit to limit the mirrored packets.
Syntax
rate-limit limit
To remove the limit, use the no rate-limit limit command.
Parameters
limit Enter the rate-limit value. The range is from 0 to 40000
Megabits per second.
Defaults 60
Command Modes CONFIGURATION
Supported Modes Full—Switch
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the FN IOM.
9.8(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
monitor session — enables a monitoring session.
show monitor session — displays the monitor session.
Port Monitoring
1191