CLI Guide

• For a Port Channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number
from 1 to 4094.
priority-value (OPTIONAL) Enter a number as the priority of this RP
Candidate, which is included in the Candidate-RP-
Advertisements. The range is 0 (highest) to 255 (lowest).
Defaults none
Command Modes CONFIGURATION
Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
ipv6 pim sparse-mode
Enable IPv6 PIM sparse mode on the interface.
Syntax
ipv6 pim sparse-mode
To disable IPv6 PIM sparse mode, use the no ipv6 pim sparse-mode
command.
Defaults Disabled.
Command Modes INTERFACE
Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Enable the interface (use the no shutdown command) and not have the
switchport command configured. Also enable Multicast globally. PIM is
supported on the port-channel interface.
PIM-Sparse Mode (PIM-SM)
1183