CLI Guide

ipv6 pim bsr-candidate
Configure the router as a bootstrap (BSR) candidate.
Syntax
ipv6 pim bsr-candidate interface [hash-mask-length] [priority]
To disable the bootstrap candidate, use the no ipv6 pim bsr-candidate
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel
then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number
from 1 to 4094.
hash-mask-length (OPTIONAL) Enter the hash mask length for RP selection.
The range is from 0 to 128. The default is 126.
priority (OPTIONAL) Enter the priority value for Bootstrap election
process. The range is from 0 to 255. The default is 0.
Defaults Refer to Parameters.
Command Modes CONFIGURATION
Supported Modes Full—Swtich
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
ipv6 pim dr-priority
Change the designated router (DR) priority for the IPv6 interface.
Syntax
ipv6 pim dr-priority priority-value
To remove the DR priority value assigned, use the no ipv6 pim dr-priority
command.
1178
PIM-Sparse Mode (PIM-SM)