CLI Guide

show running-config pim
Display the current configuration of PIM-SM snooping.
Syntax
show running-config pim
Command Modes EXEC Privilege
Supported Modes Full—Swtich
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show running-config pim
!
ip pim snooping enable
Related
Commands
ip pim sparse-mode — enables PIM-SM snooping.
IPv6 PIM-Sparse Mode Commands
The following describes the IPv6 PIM-sparse mode (PIM-SM) commands.
ipv6 pim bsr-border
Define the border of PIM domain by filtering inbound and outbound PIM-BSR messages per interface.
Syntax
ipv6 pim bsr-border
Defaults Disabled.
Command Modes INTERFACE
Supported Modes Full—Swtich
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command is applied to the subsequent PIM-BSR messages. Existing BSR
advertisements are cleaned up by time-out.
PIM-Sparse Mode (PIM-SM)
1177