CLI Guide

Supported Modes Full—Swtich
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Example
E600-7-rpm0#show ip pim bsr-router
PIMv2 Bootstrap information
This system is the Bootstrap Router (v2)
BSR address: 7.7.7.7 (?)
Uptime: 16:59:06, BSR Priority: 0, Hash mask length: 30
Next bootstrap message in 00:00:08
This system is a candidate BSR
Candidate BSR address: 7.7.7.7, priority: 0, hash mask
length: 30
show ip pim interface
View information on the interfaces with IP PIM enabled.
Syntax
show ip pim interface
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full—Swtich
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show ip pim interface command shown in the
following example.
Field Description
Address Lists the IP addresses of the interfaces participating in PIM.
Interface List the interface type, with either slot/port information or ID
(VLAN or Port Channel), of the interfaces participating in
PIM.
Ver/Mode Displays the PIM version number and mode for each
interface participating in PIM:
• v2 = PIM version 2
1166
PIM-Sparse Mode (PIM-SM)