CLI Guide

To remove the restriction, use the no ip pim neighbor-filter {access-
list} command.
Parameters
access-list Enter the name of a standard access list. Maximum 16
characters.
Defaults none
Command Modes CONFIGURATION
Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Do not enter this command before creating the access-list.
ip pim query-interval
Change the frequency of PIM Router-Query messages.
Syntax
ip pim query-interval seconds
To return to the default value, use the no ip pim query-interval seconds
command.
Parameters
seconds Enter a number as the number of seconds between router
query messages. The range is from 0 to 65535. The default
is 30 seconds.
Defaults 30 seconds
Command Modes INTERFACE
Supported Modes Full—Swtich
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
1160
PIM-Sparse Mode (PIM-SM)