CLI Guide

• psh = push function
• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent field
source Enter the IP address of the network or host from which the
packets were sent.
mask Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all traffic is subject to
the filter.
host ip-address Enter the keyword host then the IP address to specify a
host IP address.
destination Enter the IP address of the network or host to which the
packets are sent.
operator (OPTIONAL) For TCP and UDP parameters only. Enter one
of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two
ports for theport command parameter.)
Defaults none
Command Modes REDIRECT-LIST
Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Added the keyword track-id on the MXL.
9.4(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
8.4.2.1 Introduced on the C-Series.
8.4.2.0 Introduced on the E-Series TeraScale.
Policy-based Routing (PBR)
1149