CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
Usage Information
If you enable BFD at the global level, show ipv6 ospf interface shows the BFD
provisioning.
If you enable BFD at the interface level, show ipv6 ospf interface shows the BFD
interval timers.
Example
Dell#show ipv6 ospf interface Tengigabitethernet 1/0
TenGigabitEthernet 1/0 is up, line protocol is up
Link Local Address fe80::201:e8ff:fe17:5bbd, Interface ID
67420217
Area 0, Process ID 1, Instance ID 0, Router ID 11.1.1.1
NetworkType BROADCAST, Cost: 1, Passive: No
Transmit Delay is 100 sec, State DR, Priority 1
Interface is using OSPF global mode BFD configuration.
Designated router on this network is 11.1.1.1 (local)
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 1,
Retransmit 5
Dell#
show ipv6 ospf neighbor
Display the OSPF neighbor information on a per-interface basis.
Syntax
show ipv6 ospf neighbor [interface]
Parameters
interface
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a VLAN, enter the keyword vlan then the VLAN ID.
The range is 1 to 4094.
Defaults none
Command Modes
EXEC
Open Shortest Path First (OSPFv2 and OSPFv3)
1141