CLI Guide

ipv6 ospf cost
Explicitly specify the cost of sending a packet on an interface.
Syntax
ipv6 ospf interface-cost
Parameters
interface-cost
Enter a unsigned integer value expressed as the link-state
metric. The range is from 1 to 65535.
Defaults Default cost based on the bandwidth.
Command Modes INTERFACE
Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
In general, the path cost is calculated as:
10^8 / bandwidth
Using this formula, the default path cost is calculated as:
• TenGigabitEthernet—Default cost is 1
• Ethernet—Default cost is 10
ipv6 ospf dead-interval
Set the time interval since the last hello-packet was received from a router. After the time interval elapses,
the neighboring routers declare the router down.
Syntax
ipv6 ospf dead-interval seconds
Parameters
seconds
Enter the time interval in seconds. The range is from 1 to
65535 seconds.
Defaults 40 seconds (Ethernet).
Command Modes INTERFACE
Supported Modes Full—Switch
Open Shortest Path First (OSPFv2 and OSPFv3)
1129