CLI Guide

auto-cost
Specify how the OSPF interface cost is calculated based on the reference bandwidth method.
Syntax
auto-cost [reference-bandwidth ref-bw]
To return to the default bandwidth or to assign cost based on the interface type,
use the no auto-cost [reference-bandwidth ref-bw] command.
Parameters
ref-bw (OPTIONAL) Specify a reference bandwidth in megabits per
second. The range is from 1 to 4294967. The default is 100
megabits per second.
Defaults 100 megabits per second.
Command Modes ROUTER OSPFv3
Supported Modes Full-Switch
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0)
Introduced on the FN IOM
9.9(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Example
Dell#show running-config ospf
!
ipv6 router ospf 10
log-adjacency-changes
auto-cost reference-bandwidth 2000
Dell(conf-ipv6-router_ospf)#auto-cost reference-bandwidth ?
<1-4294967> Reference bandwidth in Mbits/second
(default = 100)
Dell(conf-ipv6-router_ospf)#no auto-cost ?
reference-bandwidth Use reference bandwidth method to
assign OSPF cost
<cr>
Dell(conf-ipv6-router_ospf)#
1120
Open Shortest Path First (OSPFv2 and OSPFv3)