CLI Guide

timers throttle lsa arrival
Configure the LSA acceptance intervals.
Syntax
timers throttle lsa arrival arrival-time
To return to the default, use the no timers throttle lsa command.
Parameters
arrival-time Set the interval between receiving the same LSA repeatedly,
to allow sufficient time for the system to accept the LSA.
The range is from 0 to 600,000 milliseconds.
Defaults 1000 msec
Command Modes ROUTER OSPF
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
OSPFv3 Commands
The fundamental mechanisms of OSPF (flooding, DR election, area support, SPF calculations, and so on)
remain unchanged. However, OSPFv3 runs on a per-link basis instead of on a per-IP-subnet basis. Most
changes were necessary to handle the increased address size of IPv6.
The Dell Networking implementation of OSPFv3 is based on IETF RFC 2740.
area authentication
Configure an IPsec authentication policy for OSPFv3 packets in an OFSPFv3 area.
Syntax
area area-id authentication ipsec spi number {MD5 | SHA1} [key-
encryption-type] key
Parameters
area area-id
Area for which OSPFv3 traffic is to be authenticated. For
area-id, you can enter a number.
The range is from 0 to 4294967295.
1116
Open Shortest Path First (OSPFv2 and OSPFv3)