CLI Guide

display output of this command, the problem is with downloading the route to the
RTM.
This command has the following limitations:
• The display output is sorted by prefixes; intra-area ECMP routes are not
displayed together.
• For Type 2 external routes, Type 1 cost is not displayed.
Example
Dell#show ip ospf 100 route
Prefix Cost Nexthop Interface Area Type
1.1.1.1 1 0.0.0.0 Lo 0 0 Intra-Area
3.3.3.3 2 13.0.0.3 Te 0/4 1 Intra-Area
13.0.0.0 1 0.0.0.0 Te 0/4 0 Intra-Area
150.150.150.0 2 13.0.0.3 Te 0/4 - External
172.30.1.0 2 13.0.0.3 Te 0/4 1 Intra-Area
Dell#
show ip ospf statistics
Display OSPF statistics.
Syntax
show ip ospf process-id statistics global | [interface name
{neighbor router-id}]
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
global Enter the keyword global to display the packet counts
received on all running OSPF interfaces and packet counts
OSPF neighbors receive and transmit.
interface name (OPTIONAL) Enter the keyword interface then one of the
following interface keywords and slot/port or number
information:
• For Port Channel groups, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number
from 1 to 4094.
neighbor router-
id
(OPTIONAL) Enter the keyword neighbor then the
neighbor’s router-id in dotted decimal format (A.B.C.D.).
Defaults none
1108
Open Shortest Path First (OSPFv2 and OSPFv3)