CLI Guide

show ip ospf database opaque-link
Display the opaque-link (type 9) LSA information.
Syntax
show ip ospf process-id database opaque-link [link-state-id]
[adv-router ip-address]
Parameters
process-id Enter the OSPF process ID to show a specific process. If you
do not enter the process ID, the command applies only to
the first OSPF process.
link-state-id (OPTIONAL) Specify LSA ID in dotted decimal format. The
LSA ID value depends on the LSA type, and it can be one of
the following:
• the network’s IP address for Type 3 LSAs or Type 5 LSAs
• the router’s OSPF router ID for Type 1 LSAs or Type 4
LSAs
• the default destination (0.0.0.0) for Type 5 LSAs
adv-router ip-
address
(OPTIONAL) Enter the keywords adv-router then the IP
address of an Advertising Router to display only the LSA
information about that router.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
show ip ospf database — displays OSPF database information.
show ip ospf database router
Display the router (type 1) LSA information.
Syntax
show ip ospf process-id database router [link-state-id] [adv-
router ip-address]
Parameters
process-id Enter the OSPF Process ID to show a specific process. If you
do not enter a process ID, the command applies only to the
first OSPF process.
Open Shortest Path First (OSPFv2 and OSPFv3)
1099