CLI Guide

The default keyword sets all interfaces as passive. You can then configure
individual interfaces, where adjacencies are desired, using the no passive-
interface
interface command. The no form of this command is inserted into
the configuration for individual interfaces when the no passive-interface
interface command is issued while passive-interface default is
configured.
This command behavior has changed as follows:
passive-interface interface
• The previous no passive-interface interface is removed from the
running configuration.
• The ABR status for the router is updated.
• Save passive-interface interface into the running configuration.
passive-interface default
• All present and future OSPF interfaces are marked as passive.
• Any adjacency is explicitly terminated from all OSPF interfaces.
• All previous passive-interface interface commands are removed from
the running configuration.
• All previous no passive-interface interface commands are removed
from the running configuration.
no passive-interface interface
• Remove the interface from the passive list.
• The ABR status for the router is updated.
• If passive-interface default is specified, then save no passive-
interface
interface into the running configuration.
No passive-interface default
• Clear everything and revert to the default behavior.
• All previously marked passive interfaces are removed.
• May update ABR status.
redistribute
Redistribute information from another routing protocol throughout the OSPF process.
Syntax
redistribute {connected | rip | static} [metric metric-value |
metric-type type-value] [route-map map-name] [tag tag-value]
To disable redistribution, use the no redistribute {connected | isis |
rip | static} command.
1080
Open Shortest Path First (OSPFv2 and OSPFv3)