CLI Guide
isis (OPTIONAL) Enter the keyword isis to specify that IS-IS
routes are distributed.
rip (OPTIONAL) Enter the keyword rip to specify that RIP
routes are distributed.
static (OPTIONAL) Enter the keyword static to specify that only
manually configured routes are distributed.
Defaults Not configured.
Command Modes ROUTER OSPF
Supported Modes Full—Switch
Command History
Version Description heading
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The distribute-list out command applies to routes autonomous system
boundary routers (ASBRs) redistributes into OSPF. It can be applied to external type
2 and external type 1 routes, but not to intra-area and inter-area routes.
fast-convergence
This command sets the minimum LSA origination and arrival times to zero (0), allowing more rapid route
computation so that convergence takes less time.
Syntax
fast-convergence {number}
To cancel fast-convergence, use the no fast convergence command.
Parameters
number Enter the convergence level desired. The higher this
parameter is set, the faster OSPF converge takes place. The
range is from 1 to 4.
Defaults none.
Command Modes ROUTER OSPF
Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The higher this parameter is set, the faster OSPF converge takes place.
1066
Open Shortest Path First (OSPFv2 and OSPFv3)