CLI Guide

Parameters

area-id Specify the OSPF area in dotted decimal format (A.B.C.D.) or

enter a number from zero (0) to 65535.

no-summary (OPTIONAL) Enter the keywords no-summary to prevent

the ABR from sending summary Link State Advertisements

(LSAs) into the stub area.

Defaults Disabled.

Command Modes ROUTER OSPF

Supported Modes Full—Switch

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information To configure all routers and access servers within a stub, use this command.

Commands

router ospf — enters ROUTER OSPF mode to configure an OSPF instance.

auto-cost

Specify how the OSPF interface cost is calculated based on the reference bandwidth method.

Syntax

auto-cost [reference-bandwidth ref-bw]

To return to the default bandwidth or to assign cost based on the interface type,

use the no auto-cost [reference-bandwidth] command.

Parameters

ref-bw (OPTIONAL) Specify a reference bandwidth in megabits per

second. The range is from 1 to 4294967. The default is 100

megabits per second.

Defaults 100 megabits per second.