CLI Guide

ManualsBrandsDell ManualsAccess PlatformsFN IO Module

1051

Defaults cost = 1; no areas are configured.

Command Modes ROUTER OSPF

Supported Modes Full—Switch

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information In the Dell Networking operating software, cost is defined as reference bandwidth.

Commands

area stub — creates a stub area.

area nssa

Specify an area as a not so stubby area (NSSA).

Syntax

area area-id nssa [default-information-originate] [no-

redistribution] [no-summary]

To delete an NSSA, use the no area area-id nssa command.

Parameters

area-id Specify the OSPF area in dotted decimal format (A.B.C.D.) or

enter a number from zero (0) to 65535.

no-redistribution (OPTIONAL) Specify that the redistribute command

does not distribute routes into the NSSA. Only use this

command in an NSSA area border router (ABR).

default-

information-

originate

(OPTIONAL) Allows external routing information to be

imported into the NSSA by using Type 7 default.

no-summary (OPTIONAL) Specify that no summary LSAs should be sent

into the NSSA.

Defaults Not configured.