CLI Guide

ENode WWNN : 10:00:00:00:c9:d9:9c:cd
FCoE MAC : 0e:fc:03:01:02:02
FC-ID : 01:02:01
LoginMethod : FDISC
Secs : 5593
Status : LOGGED_IN
Related
Commands
dcb-map— creates a DCB map to configure DCB parameters on Ethernet ports
that support converged Ethernet traffic.
fcoe-map — creates an FCoE map which contains the parameters used in the
communication between servers and a SAN fabric.
show qos dcb-map
Display the DCB parameters configured in a specified DCB map.
Syntax
show qos dcb-map map-name
Parameters
map-name Displays the PFC and ETS parameters configured in the
specified map.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.6(0.0) Supported on the FN I/O Aggregator.
9.6(0.0) Supported on the M I/O Aggregator.
Usage Information
Use the show qos dcb-map command to display the enhanced transmission
selection (ETS) and priority-based flow control (PFC) parameters used to configure
server-facing Ethernet ports.
The following table describes the show qos dcb-map output shown in the
example below.
Field Description
State Complete: All mandatory DCB parameters are correctly
configured. In progress: The DCB map configuration is not
complete. Some mandatory parameters are not configured.
1052
NPIV Proxy Gateway