CLI Guide

show fcoe-map— displays the Fibre Channel and FCoE configuration parameters in
FCoE maps.
fabric-id vlan
In an FCoE map, configure the association between the dedicated VLAN used to carry FCoE traffic
between servers and a SAN, and the fabric where the desired storage arrays are installed.
Syntax
fabric-id fabric-num vlan vlan-id
Parameters
fabric-id fabric-
num
Enter a fabric ID number that is the same as the ID number
of the dedicated VLAN used to carry FCoE storage traffic to
the fabric specified in the FCoE map. You can enter a fabric
ID in the range 2–4094.
vlanvlan-id Enter the ID number of the dedicated VLAN used to carry
FCoE storage traffic between servers and a SAN fabric and
specified with the vlan command in the FCoE map.
Defaults None
Command Modes FCOE MAP
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.6(0.0) Supported on the FN 2210S Aggregator.
9.3(0.0) Supported on the M I/O Aggregator.
Usage Information
In the fabric-id vlan command, the fabric and VLAN ID numbers must be the
same.
In each FCoE map, the fabric ID, FC-MAP value, and FCoE VLAN parameters must
be unique.
To remove a fabric-VLAN association from an FCoE map, enter the no fabric-id
vlan command.
Create a VLAN and then specify the configured VLAN ID in the fabric-id vlan
command. Otherwise, the following error message is displayed.
Dell(conf-fcoe-f)#fabric-id 10 vlan 10 % Error: Vlan 10 does
not exist
NPIV Proxy Gateway
1039