CLI Guide

• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
hardware_address Enter a 48-bit hardware MAC address in nn:nn:nn:nn:nn:nn
format.
Defaults none
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
show ipv6 neighbors
Display IPv6 discovery information. Entering the command without options shows all the IPv6 neighbor
addresses stored on the control processor (CP).
Syntax
show ipv6 neighbors [vrf vrf-name] [ipv6-address| interface
interface]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to display the neighbors corresponding to that VRF.
NOTE: If you do not specify this option, neighbors
corresponding to the default VRF are displayed.
ipv6-address Enter the IPv6 address of the neighbor in the x:x:x:x::x
format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
interface interface Enter the keyword interface then the interface type and
slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
fastEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then the VLAN ID.
The range is from 1 to 4094.
Neighbor Discovery Protocol (NDP)
1035