CLI Guide

interface interface To remove all neighbor entries learned on a specific
interface, enter the keyword interface then the interface
type and slot/port or number information of the interface:
• For a Fast Ethernet interface, enter the keyword
fastEthernet then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then the VLAN ID.
The range is from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
ipv6 neighbor
Configure a static entry in the IPv6 neighbor discovery.
Syntax
ipv6 neighbor {ipv6-address} {interface interface}
{hardware_address}
To remove a static IPv6 entry from the IPv6 neighbor discovery, use the no ipv6
neighbor {ipv6-address} {interface interface} command.
Parameters
ipv6-address Enter the IPv6 address of the neighbor in the x:x:x:x::x
format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
interface interface Enter the keyword interface then the interface type and
slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
fastEthernet then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number.
1034
Neighbor Discovery Protocol (NDP)