CLI Guide

To disable logging, use the no ip msdp log-adjacency-changes command.
Defaults Not configured.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
ip msdp mesh-group
To be a member of a mesh group, configure a peer.
Syntax
ip msdp mesh-group {name} {peer address}
To remove the peer from a mesh group, use the no ip msdp mesh-group
{name} {peer address} command.
Parameters
name Enter a string of up to 16 characters long for as the mesh
group name.
peer address Enter the peer address in a dotted decimal format (A.B.C.D.).
Defaults Not configured.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information An MSDP mesh group is a mechanism for reducing SA flooding, typically in an
intra-domain setting. When some subset of a domain’s MSDP speakers are fully
meshed, they can be configured into a mesh-group. If member X of a mesh-group
receives a SA message from an MSDP peer that is also a member of the mesh-
group, member X accepts the SA message and forwards it to all of its peers that are
not part of the mesh-group. However, member X cannot forward the SA message
to other members of the mesh-group.
Multicast Source Discovery Protocol (MSDP)
1001