Administrator Guide

mVLT Configuration Example
The following example demonstrates the steps to configure multi-domain VLT (mVLT) in a network.
In this example there are two domains being configured. Domain 1 consists of Peer 1 and Peer 2; Domain 2
consists of Peer 3 and Peer 4 as shown.
Figure 123. mVLT Configuration Example
In Domain 1, configure Peer 1 first, then configure Peer 2. When that is complete, perform the same steps for
the peer nodes in Domain 2. The interface used in this example is TenGigabitEthernet.
In Domain 1, configure the VLT domain and
VLTi on Peer 1
Domain_1_Peer1#configure
Domain_1_Peer1(conf)#interface port-channel 1
Domain_1_Peer1(conf-if-po-1)#channel-member TenGigabitEthernet 0/8-9
Domain_1_Peer1#no shutdown
Domain_1_Peer1(conf)#vlt domain 1000
Domain_1_Peer1(conf-vlt-domain)#peer-link port-channel 1
Virtual Link Trunking (VLT) 982