Administrator Guide

{ip address ipv4-address/ mask | ipv6 address ipv6-address/ mask}
This is the IP address to be configured on the VLT peer with the back-up destination command.
3 Ensure that the interface is active.
MANAGEMENT INTERFACE mode
no shutdown
4 Repeat Steps 1 to 3 on the VLT peer switch.
To set an amount of time, in seconds, to delay the system from restoring the VLT port, use the delay-
restore
command at any time. For more information, refer to VLT Port Delayed Restoration.
Configuring a VLT Port Delay Period
To configure a VLT port delay period, use the following commands.
1 Enter VLT-domain configuration mode for a specified VLT domain.
CONFIGURATION mode
vlt domain domain-id
The range of domain IDs from 1 to 1000.
2 Enter an amount of time, in seconds, to delay the restoration of the VLT ports after the system is
rebooted.
CONFIGURATION mode
delay-restore delay-restore-time
The range is from 1 to 1200.
The default is 90 seconds.
Reconfiguring the Default VLT Settings
(Optional)
To reconfigure the default VLT settings, use the following commands.
1 Enter VLT-domain configuration mode for a specified VLT domain.
CONFIGURATION mode
vlt domain domain-id
The range of domain IDs is from 1 to 1000.
2 (Optional) After you configure the VLT domain on each peer switch on both sides of the interconnect
trunk, by default, the system elects a primary and secondary VLT peer device.
VLT DOMAIN CONFIGURATION mode
Virtual Link Trunking (VLT) 967