Administrator Guide

Displaying NPIV Proxy Gateway
Information
To display information on the NPG operation, use the show commands in the following table:
Table 69. Displaying NPIV Proxy Gateway Information
Command Description
show interfaces status
Displays the operational status of Ethernet and Fibre Channel
interfaces on the Aggregator with the NPG.
NOTE: Although the show interface status command
displays the Fiber Channel (FC) interfaces with the
abbreviated label of 'Fc' in the output, if you attempt to
specify a FC interface by using the interface fc
command in the CLI interface, an error message is
displayed. You must configure FC interfaces by using the
interface fi command in CONFIGURATION mode.
show fcoe-map [brief | map-name]
Displays the Fibre Channel and FCoE configuration parameters in
FCoE maps. Enter the brief keyword to display an overview of
currently configured FCoE maps.
Enter the name of an FCoE map to display the FC and FCoE
parameters configured in the map to be applied on the
Aggregator with the FC ports.
show qos dcb-map
map-name
Displays configuration parameters in a specified DCB map.
show npiv devices [brief]
Displays information on FCoE and FC devices currently logged in
to the NPG.
show fc switch
Displays the FC mode of operation and worldwide node (WWN)
name of an Aggregator.
show interfaces status Command Example
Dell# show interfaces status
Port Description Status Speed Duplex Vlan
Te 0/1 Up 10000 Mbit Full 1-4094
Te 0/2 Down Auto Auto 1-1001,1003-4094
Te 0/3 Up 10000 Mbit Full 1-1001,1003-4094
Te 0/4 Down Auto Auto 1-1001,1003-4094
Te 0/5 Up 10000 Mbit Full 1-4094
Te 0/6 Up 10000 Mbit Full 1-4094
Te 0/7 Up 10000 Mbit Full 1-4094
Te 0/8 toB300 Down Auto Auto 1-1001,1003-4094
Fc 0/9 Up 8000 Mbit Full --
Fc 0/10 Up 8000 Mbit Full --
NPIV Proxy Gateway 935