Administrator Guide

INTERFACE mode
service-queue
Specifying an Aggregate QoS Policy
To specify an aggregate QoS policy, use the following command.
• Specify an aggregate QoS policy.
POLICY-MAP-OUT mode
policy-aggregate
Applying an Output Policy Map to an Interface
To apply an output policy map to an interface, use the following command.
• Apply an input policy map to an interface.
INTERFACE mode
service-policy output
You can apply the same policy map to multiple interfaces, and you can modify a policy map after you
apply it.
Enabling QoS Rate Adjustment
By default, while rate limiting, policing, and shaping, the Dell Networking OS does not include the Preamble,
SFD, or the IFG fields. These fields are overhead; only the fields from MAC destination address to the CRC are
used for forwarding and are included in these rate metering calculations.
The Ethernet packet format consists of:
• Preamble: 7 bytes Preamble
• Start frame delimiter (SFD): 1 byte
• Destination MAC address: 6 bytes
• Source MAC address: 6 bytes
• Ethernet Type/Length: 2 bytes
• Payload: (variable)
• Cyclic redundancy check (CRC): 4 bytes
• Inter-frame gap (IFG): (variable)
You can optionally include overhead fields in rate metering calculations by enabling QoS rate adjustment.
QoS rate adjustment is disabled by default, and no qos-rate-adjust is listed in the running-configuration
• Include a specified number of bytes of packet overhead to include in rate limiting, policing, and shaping
calculations.
CONFIGURATION mode
qos-rate-adjust overhead-bytes
Quality of Service (QoS) 747