Administrator Guide

Mode Default Settings
NPIV Proxy
Gateway Mode
(NPG)
Enabled in FN 2210S; Disabled on FN 410S & FN 410T
iSCSI Optimization Enabled
Broadcast Storm
Control
Enabled
Internet Group
Management
Protocol (IGMP)
Flood Restrict
Enabled
Network Time
Protocol (NTP)
Enabled
Enable and Disable
ports
All port enabled by default. Disable ports through Command Line Interface
Uplink Failure
Detection (UFD)
Enabled
TACACS+/RADIUS
(AAA Auth/Acct;
Auth coming up)
Disabled
DHCP Enabled n client only mode
Internet Group
Management
Protocol (IGMP) v2
& v3
Enabled
Auto LACP LAG Enabled on all ports (Uplink created by default based on LACP PDU)
All VLANS Available on all server and uplink ports
Ensuring the FN IOM system is in Standalone
Mode
To ensure that the FN IOM is in Standalone Mode, use the show system stack-unit 0 iom-mode
command.
Dell#show system stack-unit 0 iom-mode
Unit Boot-Mode Next-Boot
------------------------------------------------
0 standalone
If the FN IOM system is not in the Standalone Mode, reset the system to its factory default state. To reset the
system, use the restore factory-defaults stack-unit 0 clear-all command. It brings the system
in standalone (preconfigured) mode and sets all configuration settings to a known state.
Dell#restore factory-defaults stack-unit 0 clear-all
Proceed with factory settings? Confirm [yes/no]:y
Getting Started 68